Werbung
Verfügbare Sprachen
Verfügbare Sprachen
During use, the user must wear goggles, ear protectors and protective
gloves.
During use, hold the machine with both hands and maintain a safe
standing position. Always consider the reaction moment of the
tool.
Always work with concentration. Always work in a carefully
considered way and do not use the tool if you are lacking
consideration.
For further safety instructions, please refer to the enclosure!
Before starting the machine, please check the correspondence between
voltage and frequency against the data mentioned on the identification
plate. Voltage differences of + 6 % and – 10 % are allowed.
The Hand-Held Drilling Machine EHB 20 / 2.4 is made in protection class II.
Only use extension cables with a sufficient cross section. A cross section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Additional Handle
The EHB 20/2.4 may be used only together with its additional handle
which comes with the tools.
Place it on the gearing collar from the front, bring into the requested
position and fix it tightly by counter clockwise rotation of the handle.
Instructions
Only use faultless and sharp drilling tools and avoid that the machine stops
due to overload.
Mounting the tool
Disconnect the plug from the mains before every tool
change!
Electrical Connection
Cross section in sq. mm
1.5
20 m
50 m
14
2.5
40 m
80 m
Werbung
