Hendi 273869 Benutzerhandbuch Seite 10

Do not use water jet or steam cleaner for cleaning and do not
GB
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
Cleaning
• Clean the appliance before first use and regularly.
• Never immerse the appliance in water or other liquids.
• Clean the cooled exterior surface with a slightly damp cloth or
sponge with some mild soap solution.
• Never use abrasive sponges or detergents, steel wool or
metallic utensils to clean the interior or exterior parts of the
appliance.
• Make sure the hanging lamp has been cleaned and dried be-
fore further use.
Replacing the defective light
• ATTENTION! Always disconnect the appliance from the power
supply before replacement.
• Remove the old light and replace with a new one of the same
type (not included).
• If you do not sure how to replace, contact the supplier/service
provider. (See ==> Warranty)
Maintenance
• Check the operation of the appliance regularly to prevent
problems that can cause serious accidents.
• As soon as you feel the appliance isn't working correctly or
there is a problem, stop using the appliance, shut it off and
contact the supplier.
Storage
• Before storage, always make sure the appliance has already
been disconnected from the electrical outlet and cooled down
completely.
• Store the appliance in a cool, clean and dry place.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problem Possible cause
The internal wires
are not connected
properly to the
electrical power
circuit system.
The wires of the
appliance are con-
Appliance not
nected to power
turned on.
circuit system but
not working at all.
ON / OFF switch
defective
Lamp bulb has
burned out.
10
The appliance
is turned on but
there is no light.
Heat is inadequate
Heat is excessive
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war-
ranty, state where and when it was purchased and include proof
of purchase (e.g. receipt).
In line with our policy of continuous product development we
reserve the right to change the product, packaging and docu-
mentation specifications without notice.
Possible solution
Discarding & Environment
When decommissioning the appliance, the product must not
Check again to
be disposed of with other household waste. Instead, it is your
make sure it is
responsibility to dispose to your waste equipment by handing it
connected properly.
over to a designated collection point. Failure to follow this rule
may be penalized in accordance with applicable regulations on
Turn on the appli-
waste disposal. The separate collection and recycling of your
ance by pressing
waste equipment at the time of disposal will help conserve nat-
the switch at the "I"
ural resources and ensure that it is recycled in a manner that
position.
protects human health and the environment.
Contact the
For more information about where you can drop off your waste
supplier.
for recycling, please contact your local waste collection compa-
ny. The manufacturers and importers do not take responsibility
Replaced the bulb
for recycling, treatment and ecological disposal, either directly
with the same types
and same rating. or through a public system.
Check the circuit
breaker and reset
No power to the
as necessary of the
appliance
system by qualified
technician.
ON / OFF switch Contact the
defective supplier.
Replaced the bulb
Lamp bulb has
with the same type
burned out.
and same rating.
The appliance is Lower the mount-
mounted too high ing height to closer
to the target area. to the heated area.
Verify lamp bulb
and replace with
Incorrect lamp the correct wattage
bulb wattage. bulb. Do not exceed
maximum lamp
bulb wattage.
The appliance is Increase the
mounted too close mounting height if
to the target area. too close.
Check the bulb
Lamp bulb wattage wattage and
is too high. replace with lower
wattage bulb.