eta GUSTUS III Bedienungsanleitung Seite 52

GB
– Proper mounting of the bowl lid will release safety lock and you can switch the
appliance on. The appliance cannot be started without the mounted lid.
– Do not use safety lock controlled by the bowl lid for switching off the appliance!
– Do not let the blender running without any food!
– Never remove the container lid F1 when the motor unit is running!
– Never pour boiling liquids in the container.
– Before removing the blender lid or container, wait until the rotating parts completely stop.
– When the blender is in the state of idle operation, e.g. the blade fails to touch the foods,
unplug the unit until the foods have been relaxed.
Assembly
Assemble the blender and attach it to the blender mount A9 according to Figures 10 a 11.
Instead of the plug for adding liquids F5 you can also insert the pusher F7 in the opening
in the lid if you are going to use it. Apply reverse sequence to disassemble the unit and to
remove it from the mount.
Before the first use
We recommend washing the glass container before using it for the first time. The knife
section is treated with oil not harmful to health for technological reasons. Therefore first
fill in the container with warm water (max. 50 °C) with a small amount of detergent. Then
put the container on the food processor, set the maximum rotational speed and run for 1
minute. Then rinse the container with clear water.
– Never fill the container with liquids producing foam (for example milk) up to „MAX" level
to prevent overspill. We recommend 1 litre at maximum.
Use
Remove the lid, put or pour the food into the container and replace the lid. To press larger
pieces of ingredients to the knife, use the pusher F7. We recommend that you always switch
on the blender to minimum revolutions and then gradually increase the performance as required.
The recommended processing speed is 1 – MAX.
III.6) Poppy seed grinder (H)
Description (Fig. 12)
H1 – Feeder (assembled)
H2 – Cover with hopper
H3 – Grinding discs (2 units)
Assembly
Assemble the poppy seed grinder and attach it to the motor unit head according to Fig. 12
and Fig. 7. Put the „fixed" grinding disc H3 on the feeder, slowly rotate it until three arresting
projections of the disc click into three recesses of the feeder. Then put the „mobile" grinding
disc (with the grooves lining up) on the fixed grinding disc. Put the pressure disc H4 on the
shaft so that the central projection is aligned with the grinding disc opening. Then rotate the
pressure disc until three arresting projections of the disc click into three recesses of the
feeder. Finally put on the regulating knob and tighten it.
Safety hints and tips
Tips
H4 – Pressure disc
H5 – Regulating disc
H6 – Key
52 / 111