Replacing Oven Lampbulbs - hanseatic 65M40M1-E1131A Gebrauchsanleitung

Page GB-16 Cleaning
4. Lightly lift and guide the door forward out
of its hinges.
Putting the oven door back on its
hinges
1. Hold the door on an angle using both
hands.
2. Hook the hinges into the holes in the side
panels. The oven door must be level with
the oven.
3. Open the oven door completely.
4. Fold the clips (12) on both sides all the
way back again.
5. Close the door carefully. The door must
sit flush when closed. If the door does not
sit flush when closed or if there is a crack-
ing sound when closing it, the door is not
hung properly.
6. Correct the position of the hinges and
clips, if necessary, until the door opens
and closes smoothly again.
Cleaning the glass panes
The oven door contains two glass panes that
should occasionally be cleaned on both sides.
1. Take the oven door off its hinges (see
chapter "Taking the oven door off its
hinges").
2. Place the oven door with the pane (13) on
a soft base.
3. Take both panes with one finger on each
side in the gap and on both sides push
the rear clamp (14) forward so that the
pane (15) is released from the clamp
brackets.
4. Take the pane (15) out of the oven door
5. Clean both panes with warm clean water.
6. Dry the panes thoroughly.
7. Return the pane (15) back into the oven
door and push it down firmly with the
clamps (14).
8. Replace the oven door (see chapter "Put-
ting the oven door back on its hinges").

Replacing oven lampbulbs

For oven lamping, you need a heat-resistant
oven lampbulb: 240 V~, 25 W, E14, T 300 °C.
WARNING
Risk of electric shock!
Improper replacing of the oven lamp
bulb may cause electric shock which
can lead to serious injury or even death.
Before replacing the oven bulb, be
■
sure to switch off the circuit breaker
or unscrew fuses.
Risk of burns!
The cooking compartment can re-
main hot a long time after it has been
switched off. As a result, there is a risk
of being burnt when touching the cook-
ing compartment walls or heating unit.
(g)
(f)
(e)