Elementary Operator Control; Installation - Grasslin Famoso 2000 Bedienungsanleitung

6

2.1 Elementary operator control

Your chronostat has been installed and the installation
technician has programmed the programme of your
choice to suit your specific requirements. Proceed as
follows if you wish to change the temperature temporarily:
The display shows the current room temperature
Press the button on the display once and read
the programmed temperature
Display for the set room temperature
Press the button on the display and enter
the desired temperature
Times for the change in temperature
The symbol „ " indicates the switching
state „Heating".
The temperature specified by the
programme is reactivated with the next
temperature change.
GB

3. Installation

The chronostat must be fitted / installed with
an appropriate amount of care by a suitably
qualified electrician / technician.
Switch the heating system off before commencing installation!
Notes on the line:
Number of wires 2 / line type not twisted*
Max. line length 50 m / max. line resistance 2 x 5 Ohm
*
1
TEMP+
Lift the chronostat off the stand
TEMP-
3
TEMP+
TEMP-
3
4
Electrical interference in the surrounding area can have a.
negative influence on transfer of information.
In such cases we recommend a line with a twisted pair of
cores and shielding. See the installation instructions
„Gas heaters/boilers"
2
4
Undo the screws
Remove the protective housing
Be careful not to damage the clips
Guide the connecting leads through the
cutouts in the stand
Mount the stand on a firm surface or a flush type box
7
Ø max.
3,5 mm
GB