Water Container - Candy CS C7LF-S Handbuch

5.

WATER CONTAINER

The water removed from the laundry during the drying cycle is collected in a container inside the
door of the dryer. When the container is full the
the container MUST
drying cycle.
NOTE: Very little water will collect during the first few cycles of a new machine as an internal
reservoir is filled first.
To remove the container
tank in door drawer
1. Gently pull out the
water container holding
the handle. (A)
When it is full the
water container will
weigh about 6 kg.
2. T i l t t h e w a t e r
container to empty the
water out through the
(B)
spout.
When empty, replace
the water container
(C) irst
back as shown;
insert the base of the
container into position
as shown (1) then
gentle push the top into
position (2)
.
3. Press Button
restart the cycle.
NOTE: If you have the
option of drainage near
to the dryer you can use
the discharge kit to
provide a permanent
drainage for the water
c o l l e c t e d i n t h e
container of the dryer.
This means that you
don't have to empty the
water container .
be emptied. However, we recommend that the container is emptied after each
f
to
1
indicator on the control panel will light, and
To remove the container
bottom water drawer
1. Gently pull the bottom
of the kickplate so that it
unclips from the dryer.
The top section can
t h e n b e u n h i n g e d
allowing the kickplate to
b e c o m p l e t e l y
removed. (A)
A
2. Pull firmly on the
handgrip and slide the
water container out of
the dryer. (B)
Support the container
w i t h b o t h h a n d s .
(C) When full, the water
container will weigh
about 4kg.
B
3. Open the lid located
on the top of the
container and empty
(D)
the water.
4. Refit the lid and slide
the water container
back into position.
PUSH FIRMLY INTO
PLACE.
C
5. Refit the kickplate by
engaging the hinges at
the top and 'snapping'
the lower clips into
place.
10
A
B
C
(D)
D