Cameo G4 TW Bedienungsanleitung Seite 16

DEVICE MENU (Fixture Menu):
In the RDM/Fixture menu, select Fixture Menu and confirm the selection.
CONFIGURE DMX START ADDRESS
Select DMX Address, confirm the selection, set the desired DMX address and confirm the entry.
(highest value depends on the currently activated DMX operating mode)
SELECT DMX MODE
Select DMX Mode, confirm the selection, then select the desired DMX mode and confirm the
selection.
STATIC STANDALONE MODE
The Static standalone mode allows the Dimmer, Dimmer Fine, Strobe and RGBAL values to be set
directly on the device with values between 000 and 255, in a similar way to with a DMX controller.
In this way, an individual scene can be created without an additional DMX controller.
Select Stand Alone, confirm the selection, then select Static and confirm again. Now select the
menu item you wish to edit and confirm the selection. In the selected menu item, set the desired
value from 000 to 255 and confirm the entry. The values for the strobe effect correspond to the
values in channel 3 of the DMX table 7 CH 16 bit.
16