Bottom Cover; Unpacking / Site - Pkm WA9-ES1415DI Bedienungsanleitung

2.2 Unpacking / Site

1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
3. Check that the appliance and the power cord are not damaged.
4. Do not install the appliance in a bathroom or a place where it may come in
contact with water or rain; otherwise, the insulation of the electrical system will
be damaged. Do not install the appliance in a room where explosive or flammable
gases are stored.
5. Protect the appliance from direct sunlight.
6. Install the appliance in a dry and well-ventilated place. The room temperature
must be higher than 0 °C.
7. Install the appliance in a suitable position with an adequate distance from sources
of heat and cold.
8. Do not install the appliance on a carpet / fitted carpet.
9. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
10. If you install the appliance on a wooden floor, you must also place it on a
plywood panel (60.00*60.00 cm) at least 3.00 cm thick to distribute the weight
of the appliance. Fix and secure the plywood panel properly to the wooden floor.
11. All required installations for the electric and water supply must be carried out by
a qualified professional.
Depending on model.
26
1x
1x
26
1x I
NSTRUCTION MANUAL
~ ~
88
H
OLDER
(water drain hose)
B
OTTOM COVER
(noise reduction)