Intended Use; Before First Use; Setting Up The Battery Charger; Charging The Battery - Westfalia X-SAW WXS 18-110 Originalanleitung

Intended Use

▪ The multi saw has been exclusively designed for sawing material made
of wood, such as chipboard, branches, slats, hard and soft wood. The
saw is not intended for continuous commercial use.
▪ The intended use also includes an operation following the operating
instructions.
▪ In conjunction with the extension handle, the multi-saw can be used as
a pruner for cutting branches.
▪ Any use beyond these parameters (different media, applying force) or
any changes (reconstruction, no original accessory) can lead to serious
risks and is regarded as use that is contrary to the intended purpose.

Before first Use

1. Remove the multi saw and the accessory from the packaging.
2. Check all parts for damage in transit and do not use damaged
accessory or a damaged tool.
3. Keep packaging materials out of reach of children. There is risk of
suffocation!
Setting up the Battery Charger – (Battery and Charger not included)
If fitted, remove the battery from the battery charger.
1.
Insert the battery charger mains plug into a suitable mains socket.
2.
Note: One LED on the charger will indicate ready status. For further
information please refer to the included manual of the included charger.
WARNING: Only use the charger to charge compatible batteries that are
specifically designed for this tool.
WARNING: The charger is designed for indoor use only and must not be
used in damp or wet conditions.

Charging the Battery

WARNING: Failure to follow the correct procedure when charging
batteries will result in permanent damage.
Note: Normal charging time is 1 hour for a recently discharged battery.
However, if the battery has been left in a discharged state for some time, it
may take up to 1.5 hours to charge.
Operation
44