Before The First Use; Contents Of The Package; Intended Use; Switching The Plunge Saw On And Off - Westfalia TSC110 Betriebsanleitung

Before the first Use

Remove the plunge saw and the accessories from the packaging. Check the
saw for transport damage and do not use the saw in case of damages. Keep
the packing materials away from children, risk of suffocation!

Contents of the Package

1x Plunge Saw
3x Guide Rail 33 cm
2x Connecting Rods for Guide Rail
2x Clamps for Guide Rail
1x TCT Blade 40 teeth
1x Diamond Blade
1x Hex Key 3 mm
1x Hex Key 5 mm
1x Set of Replacement Carbon Brushes
1x User Manual

Intended Use

The plunge saw is intended to cut wood and similar materials, gypsum and
cement-bonded fibre materials and plastics (TCT saw blade) and tile, granite
or concrete (diamond blade).
The plunge saw is only to be used with a specifically designed guide rail.
Installation in a different or homemade guide rail or workbench can cause
serious accidents.

Switching the Plunge Saw ON and OFF

1. Press the safety button (2b) and then the ON/OFF switch (2a) to switch the
plunge saw on.
2. Release the ON/OFF switch (2a) and the safety button (2b) to switch the
plunge saw off.
3. Pressing the locking switch (1) unlocks the plunge cut mechanism, so that
the motor can be moved downwards. The saw blade emerges from the
protective cover. When lifting the saw the motor slides back into the initial
position.
All manuals and user guides at all-guides.com
Operation
24