VOLTCRAFT VC831 Bedienungsanleitung Seite 59

Control dial (E)
Individual measurement modes are selected using the control dial. Automatic range
selection ("Autorange") is enabled in most measurement modes. The measurement
range will be selected automatically. The current measurement ranges must be set
manually. Always start current measurements with the largest measurement range,
and then switch to a smaller range if necessary.
The control dial features an indicator light that shows the setting position. Use the
"SELECT" button to switch to a sub-mode when the measurement mode has more
than one function (e.g. to switch from resistance measurement to continuity test or
from AC to DC current). The function is toggled with each press.
To switch the multimeter off, move the control dial to the "OFF" position. Always turn
the multimeter off when it is not in use.
59