JVC KW-X850BT Schnellstartanleitung Seite 11

Installing the unit (without mounting sleeve)
Remove the mounting sleeve and trim plate from the unit.
1
Align the holes in the unit (on both sides) with the vehicle
2
mounting bracket and secure the unit with screws (supplied).
wrong screws might damage the unit.
Removing the unit
Fit the catch pin on the
1
extraction keys into the holes
on both sides of the trim plate,
then pull it out.
Insert the extraction keys
2
deeply into the slots on each
side, then follow the arrows as
shown below.
Part list (supplied)
(A) Trim plate (×1)
(B) Mounting sleeve (×1)
(C) Wiring harness (×1)
(D) Extraction key (×2)
(E) Flat head screw, M5 × 8 mm (×8)
(F) Round head screw, M5 × 8 mm (×8)
Use only the specified screws. Using
Wiring connection
Fuse (10 A)
ISO connectors
Pin
A4 Yellow
A5 Blue/White
A6 Orange/white
A7 Red
A8 Black
B1, B2 Purple ], Purple/black [
B3, B4 Gray ], Gray/black [
B5, B6 White ], White/black [
B7, B8 Green ], Green/black [
Antenna terminal
a Light blue/yellow: To the
steering wheel remote control
adapter
b Yellow: Battery wire
c Yellow: A4
d Red: Ignition wire
e Red: A7
Color and function
: Battery
: Power control (12 V 350 mA)
: Car light control switch
: Ignition (ACC)
: Earth (ground) connection
: Rear speaker (right)
: Front speaker (right)
: Front speaker (left)
: Rear speaker (left)
3