Installation - Veripart VPIBKK88 Benutzerinformation

3. INSTALLATION

Before installing and assembling the refrigerator, read the safety information
(Chapter 1) carefully and the installation guide supplied separately.
1. Unpack
Remove the packaging materials and dispose of them properly. Check
that the appliance is not damaged. Do not connect the appliance if it
is damaged. Report any damage immediately to the salesperson via
customer service. In that case, keep the packaging.
2. Installation Guide
Please read the installation guide carefully before installing the
appliance.
3. Wait
Wait four hours before connecting the appliance so the oil can ow
back to the compressor.
4. Clean
Clean the interior and all internal accessories with lukewarm water and
some neutral soap before rst use to remove the typical smell of a brand
new appliance. Dry everything carefully. Do not use solvents or abrasive
powders; these will damage the coating
5. Location
The location where you place your appliance should be well ventilated
and the air should not be too warm. Do not place the appliance near a
heat source, such as a stove or boiler, and avoid direct sunlight, so that
as to guarantee the cooling effect and save on energy consumption. Do
not place the appliance in a damp place so that it cannot rust and there
is no leakage current.
37