Veripart VPIBKK88 Benutzerinformation Seite 49

PROBLEM
Poor cooling
efficiency
There is too
much frost and
ice.
The compressor
works
continuously.
The lamp does
not work.
POSSIBLE CAUSE
- Hot food has been placed inside
the appliance.
- The door does not close properly.
- The appliance is in direct sunlight
or near a stove or heater.
- The appliance is built into a
cabinet with little space around it.
- The temperature in the appliance
is set too high.
- The door is not closed properly.
- The door gasket is deformed or
dirty.
- The products are not packed
correctly.
- The temperature is set incorrectly.
- The appliance is fully loaded and
set to the lowest temperature.
- The set temperature in the
appliance is too low and the
ambient temperature is too high.
- The temperature is set incorrectly.
- Many products are placed at the
same time.
- The room temperature is too high.
- The food placed in the appliance
was too hot.
- The door is not closed properly.
- The lamp is broken.
- The lamp is in the standby
position.
SOLUTIONS
- Cool hot food before putting it
in the appliance.
- Check the door and door
rubbers and see if the door is
blocked.
- Place the appliance further
away from the heat source.
- Ensure suf cient distance to
ensure proper ventilation.
- Set the appropriate
temperature.
- Check whether something
is stopping the door from
closing. Remove or move
possible obstacles.
- As a result, the door does not
close properly. Clean the seal
and repair the deformation.
If necessary, replace the seal,
contact customer service.
- Pack the products better.
- Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Please refer to Section 4.
- Wait a few hours and then
check the temperature again.
- Please refer to Section 4.
- Allow food to cool to room
temperature before storing.
- See the previous section.
- Please contact our customer
service (or visit the nearest
Coolblue shop).
- Close and open the door.
48