Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting the Power
1. Plug the AC power cord into the power port on the back panel of the switch.
2. Connect the other end of the power cord to an AC power source.
WARNING:
Con guring the Switch
Con guring the Switch Using the Web-Based Interface
Step 1: Connect a computer to any Ethernet port of the switch using the network cable.
Step 2: Set the IP address of the computer to 192.168.1.x. ("x" is any number from 2 to 254.). Set the
subnet mask of the computer to 255.255.255.0.
1 4
1 5
1 6
1 7
1 8
1 9
2 0
2 1
2 2
2 3
8
Do not install the power cord while the power is on.
Internet Protocol Version 4 ( TCP/IPv4) Proper ties
General
You can get IP settings assigned automatically if your network
2 4
supports this capability. Otherwise, you need to ask your network
a dministrator for the appropriate IP settings
O b t a i n a n I P a d d re s s a u to m at i c a l l y
Us e t h e fo l l ow i n g I P a d d re s s :
I P a d d re s s :
2 5
S u b n e t m a s k :
2 6
S F P +
2 7
D e f a u l t g ate way
2 8
O b t a i n D N S s e r ve r a d d re s s a u to m at i c a l l y
Us e t h e fo l l ow i n g D N S s e r ve r a d d re s s :
Pre fe r re d D N S s e r ve r
Al te r n ate D N S s e r ve r
Validate settings upon exit
0 H z
V A C 5 0 /6
1 0 0 -2 4 0
x
?
1 9 2 . 1 6 8 .
1
. 2
2 2 5 . 2 2 5 . 2 2 5 . 0
.
.
.
.
.
.
.
.
.
Advanced...
OK
Cancel
Werbung
Inhaltsverzeichnis
