Clean Air Optima CA-104 Gebrauchsanweisung Seite 9

TIMING OFF/ ON
Press the button to activate the timing function.
The time selection range is 1-12 hours and is shown on the display.
In power-on state, press this button to set the working time of the machine. The timer
indicator and time indicator turn on and the digital tube flashes to display the set
time, indicating that it is in the timer setting state. At this moment, you can press the
timer button to set the time, and press any key (except the switch key) or wait 5
seconds to exit the setting. After setting the timer, the digital tube alternately displays
the set timer and current wind speed at 10 second intervals, and the wind speed
indicator and time indicator display correspondingly. When the internal timing program
reaches the set time, the machine will shut down and stay in standby state.
SWING button
Press the button to switch the swing function on or off.
The air guide slats rotate automatically when the swing function is switched on and
ensure continuous air circulation.
AIRCOOLER/ AIRHUMIDIFIER button
Fill the water tank with water first.
Press the button to activate the cooling/ humidifying function.
Cooling/ Humidifying on: the water pump starts to work and the led light is on.
Cooling/ Humidifying off: the water pump stops work and the led light is off.
Water tank empty signal
Should the water tank be empty, a tenfold acoustic signal sounds. The device will automatically
stop cooling/ air humidifing. In this case, turn off the device with the ON/ OFF button. Refill the
water tank.
If the device is switched on, the acoustic signal is off.
Dry evaporative filter
A. Press the SPEED button for 3 seconds to turn on the dry wind function, the wind will run at
the highest speed (speed 3), the LED light will flash
B. During the operation of the dry wind function, other function keys do not work. Press the
SPEED button again for 3 seconds to exit the dry wind function.
C. After running at high speed for 20 minutes, the device will automatically shut down and
enter standby mode.
Anion function: The anion function is switched on when the device starts up and switched off
once the device is switched off.
and stay on for 20 minutes.
9