Fill The Water Tank - Clean Air Optima CA-104 Gebrauchsanweisung

Fill the water tank

Attention: Make sure that the plug is not yet plugged into the socket.
Clean the water tank before using the device, see chapter
The device requires fresh drinking water for air cooling.
1. Unlock the water tank by turning the two clips from the vertical position to the horizontal
position.
2. Pull the water tank halfway out of the appliance.
3. Fill the water tank with a watering can, take into account
the maximum waterlevelindicator, see at the front of
the device.
4. Place the cooling element in the water
tank to achieve an extra cooling effect. Place the
cooling element on the right side.
5. Only fill the water tank with fresh drinking water.
You can add ice cubes to the water for
extra cooling.
Attention: Only fill the device with fresh drinking water.
The water temperature may be max. 40°C.
Attention: Change the water in the water tank every 3 days
to prevent bacterial growth.
Use of ice pack
The ice pack has unique cold storage and heat preservation properties, which can slowly ab-
sorb the heat in the water, so that the water temperature in the tank is always lower than the
ambient temperature for several hours, so that the air blowing out of the air cooler is cooler.
1. Place the ice pack in the vreezer until it is completely frozen;
2. Place the frozen ice pack into the water tank and push the water tank back to its original
position. After about ten minutes, the water temperature in the water tank will be lower than
the ambient temperature.
3. The device is equipped with 2 ice packs,
so continuous use is not a problem.
4. Do not open the lid of the ice pack!
'Cleaning and
Ice pack
maintenance'.
7