Dea NET230N Bedienungsanleitung Und Hinweise Seite 58

Allocation of CHANNEL 1 of remotes
Allocation of CHANNEL 2 of remotes
Allocation of CHANNEL 3 of remotes
Allocation of CHANNEL 4 of remotes
Selection of type of remotes
Selection type of operators
Warning: Selecting the OLI - ROCK operators, all indicated values related to the operator force (P037 - P038
- P039 - P040), are automatically set to 100% without any possibility of change. For this type of operator,
the obstacle detection is not active and the adjustment of the thrust force can be executed acting on the
operator valves only.
Selected work with or without encoders.
WARNING: P029 must be set correctly before performing the procedure for programming
Selectioning operators number
Operators speed adjustment during slow-down while opening
Operators speed adjustment during the stroke while opening
Operators speed adjustment during the stroke while closing
Operators speed adjustment during slow-down while closing
Slow down duration adjustment while opening
Slow down duration adjustment while closing
Operator 1 force adjustment while opening
(if = 100% obstacle detection deactivated)
Operator n.1 force adjustment while closing
(if = 100% obstacle detection deactivated)
TYPE 00 - 01 - 03 - 05 ONLY: Operator n.2 force adjustment while
opening (if = 100% obstacle detection deactivated)
TYPE 02 - 04 ONLY: Secondary force adjustment in closing: adjusts
the motor's force during the last part of the closing movement defi ned
by P058
Operator n.2 force adjustment while closing
(if = 100% obstacle detection deactivated)
Automatic closing times adjustment
(if = 0 automatic closing deactivated)
EN-24
Warning: For operators without
encoder, speedness during the
stroke while opening/closing
(100%) and slow down speedness
while opening/closing
are fi xed independently from set
values.
Warning: For operators without
encoder: while adjusting the force,
obstacle detection during
slowdown is ignored.
(30%)
the