Dea NET230N Bedienungsanleitung Und Hinweise Seite 50

9.2 Learning
1. Scroll down the parameters with
keys until you visualise P005;
2. Confi rm by pressing on the
3. When the symbol "
any key of the transmitter you want to memo-
rize;
4. The display visualizes the number of the trans-
mitter just memorized and then "
5. Memorize all necessary transmitters repeat-
ing this procedure from step 3;
6. Wait 10 seconds before quitting the memori-
zation mode, display shows now "- - - - ".
Warning: In the case of rolling code remotes,
the receiver can be put into learning mode by
pressing the hidden button on a remote control
previously learned.
Warning: When using personalized transmitters,
after entering P005 the learning of the fi rst
personalized transmitter is possible only by
pressing its hidden button. Afterwards, only
transmitters personalized
encryption key can be memorized (through the
usual procedure), unless a memory reset is
carried out (P004).
10 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the desire param-
eter (i.g. P032);
2. Confi rm by pressing on the
3. By pressing on
4. Confi rm by pressing on the
previously selected).
For the complete list of the "Operating Parameters" See the
table on page. EN-24.
11 Programming complete
WARNING At the end of the programming procedure, use the buttons
is now ready again for new manoeuvres.
To perform any "Advanced Programming" operations (cancellation of the remotes, confi guration inputs, etc. ..), see on page EN-17.
EN-16
and
key;
" appears, press on
";
with the same
key;
and , set up the desired value;
key (display shows the parameters
and until the appearance of the symbol "- - - - ", the operator