Cleaning And Servicing; Safety Instructions; Cleaning The Appliance - Amitek AKD200R Bedienung Und Wartung


The food products must be placed at a sufficient distance from one another. Cooling is limited
if there is very little distance between products;

The height of the racks must be chosen based on the height of the food products;

If hot meals are to be stored, let them completely cool down before placing them inside the
appliance. Putting hot food or drinks inside the appliance creates an excessive amount of steam
which can cause anomalies and malfunctions;

In the event of a power failure, if possible, do not open the door to prevent cool air from escaping;

Wait at least 10 seconds after disconnecting the plug before connecting the appliance to the
power supply line again.

6. Cleaning and servicing

6.1 Safety instructions


Disconnect the appliance from the mains electricity supply (remove the plug
from the socket) before cleaning the appliance or starting any servicing or repair
activities;

Do not use aggressive detergent products and make sure that water does not enter the control
panel or inside the appliance's technician chamber;

To prevent electric shock, never clean the appliance with a jet of water, and never immerse the
appliance or its parts, the power supply cable or the plug in water or any other liquid.
WARNING! Risk of burns!
During normal use, the surface of the compressor can become very hot. Never touch
the compressor with your bare hands.
WARNING!
The appliance is not designed to be cleaned:

With a jet of water;

With a jet of high pressure water;

By immersing it or its parts in water or any other liquid.

6.2 Cleaning the appliance

The appliance must be cleaned regularly:

Clean the inside of the appliance at least once a week;

Remove the racks and clean them with a soft cloth or sponge moistened with a delicate deter-
gent. Thoroughly dry the racks before reinserting them in the appliance;

A plastic spatula may be used if necessary or in the case of particularly stubborn dirt. The use
of metal tools is not recommended;

Clean all parts of the appliance with a soft cloth or sponge moistened with a neutral and deli-
cate detergent. Carefully dry everything after cleaning;

Only use clean water to moisten the cloth or sponge for cleaning;

Do no use abrasive detergents, such as, for example, abrasive powders, agents containing al-
cohol, bleach, diluents, etc., which could damage plastic parts, painted parts or components
made of stainless steel;

After cleaning, use a soft, dry cloth for drying the surfaces. Check that all the parts are perfectly
dry before restarting the appliance;
- 30 -
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS