Operation - Amitek AKD200R Bedienung Und Wartung


Only put food products inside the appliance after it has reached the operating temperature set
on the control unit (see paragraph 5.4 - Operation);

Food products must only be placed inside the appliance after they have been previously refrig-
erated and have reached the storage temperature;

Food products should only be placed inside the appliance if they are packaged or closed in
suitable food-grade containers.
Each support rack has a maximum capacity of 20 kg.

5.4 Operation

The appliance operates by means of digital control unit, which is used to set the desired operating
temperature.
See section 8 for more details about the control panel.
The user may carry out the following operations:
Switch on/off (see Pic.1 and Pic.3 - Section 8)
Insert the plug into the electrical socket: the current temperature inside the refrigerator will appear
on the display. In the case of a power failure, the compressor will restart approximately 3 minutes
after the power supply has been restored in order to avoid damaging the appliance by switching it
on and off multiple times.
To shut off the appliance disconnect the plug from the electrical socket. Wait at least 10 seconds
after disconnecting the plug before connecting the appliance to the power supply line again.
Display the set temperature (set point)
Press the S button once: the V
ET
Press the S button or do no press any key for 15 seconds to exit the view mode.
ET
Temperature setting (set point)
Press the S button for 3 seconds to enter the settings menu: the S
ET
shows the actual set temperature.
Proceed as follows to change the temperature setting:

Press the ▲(U
ature, respectively, until the new temperature has been reached;

Press the S button or do not press any key for 15 seconds to save the new value and exit the
ET
settings menu.
When running, the appliance will cool the cell until the currently set operating
temperature is reached. Once the set operating temperature is reached, the elec-
tronic control unit will turn off the cooling unit until the temperature detected by
the probe rises by about 4-5 degrees. When this happens, the control unit will
turn on the cooling unit to lower the temperature until it returns to the set oper-
ating temperature.
This "on-off" mechanism is perfectly normal and is common in all refrigeration
equipment such as refrigerated bars, cabinets, display cases, etc. Please note that
the temperature shown on the control unit display refers to the air temperature
(very susceptible to temperature changes due to the opening of the door) and not
to the temperature at the core of the appliance, which is much more constant
over time.
- 28 -
light lights up and the display shows the actual set temperature.
IEW
) or ▼(D
) button within 15 seconds to increase or decrease the set temper-
P OWN
light lights up and the display
ET
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS