Disposal; Installation And Operation Of The Appliance; Electrical Connection (Plug-Socket) - Amitek AKD200R Bedienung Und Wartung

4.3 Disposal

The appliance falls within the scope of Directive 2012/19/EU on the management of Waste Electrical
and Electronic Equipment (WEEE). For the disposal of the appliance, as it is made up of materials that
can be recycled at the appropriate facilities, it is necessary to make sure to entrust it to specialized
companies for both the transport and the treatment of waste. For this purpose, it is necessary to search
for companies capable of receiving the appliance for disposal and its subsequent proper recycling.
The appliance is not potentially dangerous for human health and the environment, as it does not
contain harmful substances as per Directive 2011/65/EU (RoHS), but if abandoned in the
environment it has a negative impact on the ecosystem.
The crossed-out bin symbol shown alongside, and present on the label placed on the
appliance, indicates the compliance of this product with the legislation relating to Waste
Electrical and Electronic Equipment (WEEE). To abandon the appliance in the environ-
ment or its illegal disposal are punishable by law.
WARNING! To avoid any unauthorized use and the related risks, ensure that the
appliance cannot be reactivated before disposing of it. To do this, the appliance must
be disconnected from the power supply and the power supply cable must be cut.

5. Installation and operation of the appliance

5.1 Electrical connection (plug-socket)

HAZARD! Live components!
All models have a power supply cable with a Schuko plug.
The appliance must only be connected to an electrical socket that is individually protected against
indirect contacts in compliance with the regulations in force in the country of use.
ATTENTION! Do not remove the appliance's plug by pulling the power supply cable.
ATTENTION! The power supply cable must never be placed in contact with hot objects.
ATTENTION! Do not spray water on the appliance and do not expose it to rain, water
or any other source of humidity. The appliance can cause injuries if it is not installed
correctly.
ATTENTION! Before installing the appliance compare the parameters of the local elec-
tricity mains supply with the technical data of the appliance (see the identification
plate on the rear of the appliance, Pic.2 - Section 8). Only connect the appliance to the
mains if the above-mentioned data correspond! All the safety instructions must be
complied with!
ATTENTION!

Ensure that the power supply cable does not come into contact with heat sources or sharp
edges and that it does not become blocked under the appliance. Ensure that the cable is laid
out properly, and not rolled up or bent;
- 26 -
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS