Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
press the key until hearing the sound signal. The flashing LED
T1 (grease filter) or T2 (carbon filter) stops flashing.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood command electronics
will be excluded.
This function can be useful during the product cleaning
operations.
Just repeat the operation to reinsert the electronics.
T1=
Low-speed selection key (suction power) – when
flashing it indicates the need to wash the grease filter.
T2=
Medium-speed selection key (suction power) - when
flashing it indicates the need to wash or replace the carbon
filter. This signal is normally deactivated. To activate the
alarm, disable the electronic by pressing T0 for 3 seconds.
Next, simultaneously press buttons T1 and T2 for 3 seconds;
at first, only button 1 will flash, then both buttons T1 and T2
will flash to indicate activation. Repeat the procedure to
deactivate the alarm; at first buttons T1 and T2 will flash and
subsequently only button T1 to indicate deactivation.
T3=
High-speed selection key (suction power).
T4=
Intensive speed selection key (suction power) -
duration 5 minutes: the hood sets this power and at the end of
the 5 minutes returns to the previous setting.
T5=
Light key ON/OFF.
Temperature Alarm :
The hood is equipped with a temperature sensor that activates
automatically the motor to speed 2 in case the temperature in
the control panel zone becomes too elevated.
The status of the alarm is indicated with the sequential flash of
the leds T1, T2 and T3.
The appliance go back to work at the original speed, when
the T° is lower than the threshold's one.
You can get out of this mode by pressing any button.
The sensor checks the environmental temperature of the
control panel zone every 30 second.
If the hood fails to operate correctly, briefly disconnect it from
the mains power supply for almost 5 sec. by pulling out the
plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent.
DO
NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Grease filter fig. 10-26
Traps cooking grease particles.
CLEAN
WITH
TOOLS
The grease filter must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Charcoal filter (filter version only)
NON-washable activated charcoal filter
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four months.
The charcoal filter may NOT be washed or regenerated.
CLEANING AND UPKEEP OF YOUR APPLIANCE
To keep your appliance in good working order, we
recommend that you use Clearit household products.
Clearit offers you professional products and adapted solutions
for the daily upkeep of your household and kitchen
appliances.
You may find them in conventional retail outlets, along with a
complete line of by-products and consumables.
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
The lighting system cannot be replaced by the user, contact
Customer Service in case of malfunction.
• This appliance is marked according to the European
directive 2012/19/EC - UK SI 2013 No.3113 on Waste
Electrical and Electronic Equipment (WEEE).
• By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
• The symbol
accompanying the product, indicates that this appliance may
not be treated as household waste. Instead it should be taken
to the appropriate collection point for the recycling of electrical
OR
and electronic equipment. Disposal must be carried out in
accordance with local environmental regulations for waste
disposal.
• For further detailed information regarding the process,
collection and recycling of this product, please contact the
23
fig.11-25
Professional
expertise
general public
on the product, or on the documents
for
the
Werbung
Inhaltsverzeichnis
Fehlerbehebung
