Tecfrigo CANTINETTA GLX Zusammenbau Und Betrieb Seite 7

6. CONNECTION TO THE MAINS
1.
Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance. . Ensure that there is no danger of explosion (AD) in the room. . Ensure that the 2
supply socket: a)
is properly earthed;
rating plate; c) complies with the IEC regulations:- thermal-magnetic switch with In = rated value as
stated on the rating plate; - differential with Id sensitivity = 30 mA. . Make sure the environment is
suitable for the power supply cable provided. The cable of the appliance is H05 VVF, designed for internal
use. . Insert the plug in the socket (do not use three-way adapters and reduction adapters). . 5
equipment has been transported or stored overturned,let is rest in its correct position for at least 3 hours
before hooking it up to the mains (See fig. 4)
7. CONTROLS
The controls of the appliance are situated in the compartment above the door.
setting the temperature inside the cabinet.
2. Thermometer indicating the temperature inside the cabinet (see fig. 5a).
B) 1.
Lock (Not all Appliances has lock in top,)
4. Thermostat button. 6. Light switch :The switch (6) on the top right of the control panel is for turning the
top lighting on and off. (see fig. 5b).
8. CHECKING CORRECT OPERATION, BEFORE USE
Make sure that: 1
. the plug is connected;
3 . thermostat shows the desired temperature for the goods to be stored; . the lights are turned on;
5 6
. door is firmly closed; . appliance is not exposed to direct sunlight or to powerful lamps;
temperature does not exceed +30°C with 55% R.H. (climatic class 4);
the motor compartment; there is a clearance of at least 10 cm between the wall and the rear side of the
9.
appliance; the cabinet is suitably filled and shelves are not overloaded.
9. DEFROSTING
1. Defrosting is automatic.
evaporates.
10. MAINTENANCE
1
. Use only odourless detergents to clean the inside of the appliance. . The base can be removed to
facilitate adjustment of the front feet.
11. IF THE APPLIANCE IS NOT WORKING
Before calling a technician:
has blown; 3. make sure there is not a power failure; . check if all controls have been correctly
5
programmed. . Disconnect the appliance for 15 minutes (for example the thermostat), turn it on again
and after 5 minutes check whether ice has formed on the evaporator. . Do not open the appliance unless
necessary.
12. INSTALLATION
1.
Install the appliance in a dry environment, away from direct sunlight. . Use the front feet to level the
machine (see fig. 7).
Operator's guide
fulfils the requirements of the rated current as set out on the
b)
Adjustment range:
2.
Green light indicating power on
2.
the refrigeration unit switch is turned on (green light lit up)
2. Condensation water is collected in a basin above the compressor, where it
3. Remember to clean the drainage pipe (see fig. 6).
1.
make sure the plug is correctly inserted into the socket;
7
4
A) 1. Thermostat
from 0 (off) to 7 (coldest temperature).
4
8. there is sufficient ventilation for
2
4
6
2
(A)
attached
3
N B.: If the
for
3.
Thermometer
;
7.
ambient
2.
check if the fuse
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO