Maintenance; Ipx5; Driving Instructions; Operation - SoFlow SO4 2nd Gen Originalbetriebsanleitung

3.7 Maintenance

Do not try to charge the SO4 2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO 2nd GEN when the battery is already full. This could diminish the battery's capacity in the
long run.
Before every ride, check all screws of the device, especially those of the handle and frontbar, the mudguard and the front and rear wheel. Tighten all screws firmly to
ensure safety when using your SO4 2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO 2nd GEN.
Before each journey, check that the wheels are undamaged.
Check regularly that the brakes are correctly adjusted. You can adjust the braking force by adjusting the brake cable. If in doubt, contact your dealer.
Thoroughly clean the SO4 2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO 2nd GEN with a dry cloth after usage. The front and rear ball bearings must be lubricated from
time to time. Ordinary bicycle oil can be used. Oil the area where the axle runs into the wheel to ensure better durability.

3.8 IPX5

The SO4 2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO 2nd GEN is splash-proof according to IPX5 but not waterproof. You may therefore use the SO4 2nd GEN / SO4 3rd
GEN/ SO4 PRO / SO4 PRO 2nd GEN in light rain and drive through puddles on the ground. You must not immerse the SO4 2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO
2nd GEN in water or expose it to heavy rain, otherwise the electronics may be damaged. Further information about the scope of protection according to IPX5 can be
found on the Internet.
Definition IPX5
IP First digit for protection against solid particles
X Not specified

4 Driving instructions

4.1 Operation

First, switch on your SO4 2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO 2nd GEN by pressing and holding the start button for a few seconds. You can switch off your SO4
2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO 2nd GEN by pressing and holding the same button for a few seconds. If you only press the light button for a few seconds,
you will switch off the light that is on by default. By pressing it again, you switch the light back on
Before starting your journey, make sure that the handlebars click into place.
You start with the SO4 2nd GEN / SO4 3rd GEN/ SO4 PRO / SO4 PRO 2nd GEN by using one leg to accelerate yourself and the device by pushing your foot off the ground
(like a conventional scooter). Now you can accelerate by pushing down the throttle lever on the right side of the handlebar.
copyright by www.soflow.comm
IP Digit 2 for protection against liquids
5 Protection against water jets
18