Programming The Controller (Continued); Setting Station Run Times (Length Of Watering For Each Area); Setting Days To Water; Selecting Specific Days Of The Week To Water - Hunter EC Bedienungs- Und Montageanleitung

PROGRAMMING THE CONTROLLER (cont.)
NOTE: If a program has all four-start times turned off,
then that program is off. (All other program details are
retained.) Because there are no start times, there will
be no watering with that program. This is a convenient
way to stop watering on one program only without turn-
ing the dial to the OFF position.
Setting Station Run Times
(Length of Watering for Each Area)
1. Turn the dial to the RUN TIMES position.
2. The display will show the last program
selected (A, B or C) the station number
selected, run time icon, and the run time for
that station will be flashing. You can switch to another program by
pressing the button.
3. Use the or button to change the station run time on the display.
4. Press the button to advance to the next station.
5. Repeat steps 3 and 4 for each station.
6. You can set station run times anywhere from 0 to 4 hours.
7. You can move between programs while staying on the same sta-
tion. However, it is recommended that one program is completed
before going on to the next program.

Setting Days To Water

1. Turn the dial to the WATER DAYS position.
2. The display will show the last program
selected (A, B or C). You can switch to
another program by pressing the
3. The controller will display the seven days of the week with a
icon or a icon above the numbered day. The
represent an "On" water day, while a
"Off" watering day.
RUN TIMES
WATER DAYS
button.
icon would
icon would represent an
Selecting Specific Days of the Week to Water
1. With the cursor on a specific day (the
cursor always starts with 1), press the
button to activate a particular day of the
week to water. Press the
cancel watering for that day. After pressing a button the cursor
automatically advances to the next day.
2. Repeat step 1 until all desired days have been selected. The se-
lected days will show with a
last is the last day of watering for that program.

Selecting Interval Watering

With this option you can select interval water-
ing from 1 to 31 days.
1. With the cursor on day 7, press the
button until the two calendars and a flashing 1 appear in the
display. Interval watering schedule appears on the display.
2. Press the or button to select the number of days between
watering days (1 to 31). This is called the interval.
The controller will water the selected program at the next Start Time
and will then water at the interval programmed.

Automatic

After programming is complete, turn the dial to AUTOMATIC
to enable automatic execution of all selected programs and
start times. Watering will not occur unless dial is in the
AUTOMATIC position.

System Off

Valves currently watering will be shut off after the
dial is turned to the SYSTEM OFF position for two
seconds. All active programs are discontinued and
watering is stopped. To return controller to normal
automatic operation, simply return dial to AUTOMATIC position.
1 1 2 2 3 3 4 4 5 5
button to
to indicate their status as ON. The
SYSTEM OFF
ENG
6 6 7 7
AUTOMATIC
8