Removing The Front Wheel - Gazelle Innergy Serie Bedienungsanleitung

Removing the front wheel

• T he below instructions are an addition to the
actions described in the general Gazelle user
manual. You must first follow the below instructions
before you can remove the front wheel.
• R emove the battery from the bike (see previous
instructions).
• L oosen the two screws of the connector cap on
the front fork using a size 4 Allen key. (Photo 47)
• Remove the front part of the cap. (Photo 48)
• W ith dry hands, carefully remove the connector in
the transparent crimp sheath from the casing,
gently pulling the two ends apart. It's possible that
you may first need to cut the cable tie located on
the lower section of the crimp sheath. Leave the
crimp sheath in place on the upper connector/
cable. (afb. 48 + 49)
A
• A void all contact with the contact pins of the
plugs.
• H old the bottom part of the cable and carefully
take it out of the 2 cable guide brackets. Make sure
that you do not damage the cable and plug. The
upper bracket is located in the area of the
mudguard attachment (see 1 on Photo 50), the
lower bracket is situated beneath the front axle's
cap nut (see 2 on Photo 50).
• N ow loosen the cap nuts and follow the
instructions for replacing a wheel in the general
user manual.
Repairings
47
48
49
50
1
2
48
A
79