Programming:
PRetop 5335 can be configured in the following 3 ways:
1 With PR electronics A/S' communications interface Loop Link and PReset PC
configuration software.
®
2. With a HART
modem and PReset PC configuration software.
®
3. With a HART
communicator with PR electronics A/S' DDL driver.
1: Loop Link:
For programming please refer to the drawing below and the help functions in
PReset.
Loop Link is not approved for communication with modules installed in
hazardous (Ex) areas.
26
®
2: HART
modem:
For programming please refer to the drawing below and the help functions in
PReset.
®
3: HART
communicator:
For programming please refer to the drawing below. To gain access to product-
®
specific commands, the HART
PR electronics A/S DDL driver. This can be ordered either at the HART
Commu nica tion Foundation or at PR electronics A/S.
communicator must be loaded with the
®
27