Bellman & Symfon Audio Maxi BE2020 Gebrauchsanweisung Seite 64

64
Tone control lock
To prevent that the tone control is accidentally changed by the user it is possible to lock the tone
control.
1. While the Maxi is off press and hold the g button (10). Switch on the Maxi, by pressing
the On/Off button h (5). Keep the g button held down until the Maxi's lights (3, 4) have
stopped flashing.
2. One of the LED in the Volume and Tone LED Indicator (8) will be flashing, this will be the
set tone level. Adjust the preset tone level by using the Tone control fg (10).
If all the LED's on the Volume and Tone LED Indicator (8), except the blinking one, are lit
at the same time, it means that the Tone control is activated while if the rest of the LED's are
off the Tone control is deactivated.
3. Press the c button to activate the Tone control or press the b button to deactivate the Tone
control.
4. Switch the Maxi off using the On/Off button h (5) to save these settings.
Testing
It is easy to test the Bellman Audio Maxi digital communication aid for yourself. If Maxi is
not working as described below, you can carry out further troubleshooting as instructed in the
section Troubleshooting/Troubleshooting guide.
How to test
The internal microphone and telecoil can be tested by connecting BE9122 Bellman Audio
Headphones to the Headphone output (12) and then selecting the Internal microphone (2) using
the Microphone Selection Button a (6) or the Telecoil Selection Button d (7).
The External sound source input (1) can be tested by connecting a CD player or a radio to
the input via an audio cable. Switching to the External signal source input (1) takes place
automatically when the connector is connected to the External sound source input (1) on Maxi.
BE2020_005MAN014_book.indb 64 2009-09-03 16:52:03