Bellman & Symfon Audio Maxi BE2020 Gebrauchsanweisung Seite 62

62
Appendix
Connection
Normally when you use Bellman Audio Maxi digital communication aid, you place it on a
table, hold it in your hand, hang it round your neck using a neck strap (accessory) or attach it to
an article of clothing with the clip supplied (18).
You can connect BE9122 Bellman Audio Headphones, BE9128 Bellman Audio Neck Loop,
BE9125 Bellman Audio Stetoclips, BE9124 Bellman Audio Ear Phones or another product
recommended by Bellman & Symfon to the Headphone Output (12).
You can connect a BE9126 Bellman Audio Cable Kit to the External Sound Source Input (1),
which you can connect to the required sound source or a BE9127 Bellman Audio External
Microphone. It has a 5 metre long cable so that it can, for example, be positioned next to the TV
or someone who is speaking.
Press on the On/Off button h (5) to start Maxi. While Maxi is starting up, the Microphone
LED (3) and the Telecoil LED (4) blinks. When the Microphone LED (3) comes on, Maxi is
ready to use and you will hear sound from the internal microphone in the headphones.
Settings
Bellman Audio Maxi has more setting options than those found on the front. You can adjust and
adapt Maxi to your individual requirements using the Setting button (15).
Balance
The balance between the right and left channels can be set, e.g. for headphones. This setting
can be used to compensate for a hearing loss in one ear.
The standard setting is centred balance.
All settings are carried out in sequence, see below under Adjusting settings.
Basic attenuation
The basic attenuation can be set, for example, for different headphones. What you actually set is
the attenuation you require at the maximum power output you want to have (which is therefore
0 dB attenuation). This setting is useful when you want to adjust the maximum volume for a
pair of headphones or in-ear phones with a higher sensitivity than the BE9122 Bellman Audio
Headphones.
The standard setting is 0 dB attenuation.
All settings are carried out in sequence, see below under Adjusting settings.
Blocking the T position
The Telecoil Selection Button can be blocked if you know that the T position will not be used.
This setting is for those who will never use the Telecoil and want to avoid selecting this position
by mistake.
The standard setting is for blocking of the T position not to be activated.
All settings are carried out in sequence, see below under Adjusting settings.
BE2020_005MAN014_book.indb 62 2009-09-03 16:52:01