Noise Information; Rechargeable Battery; Inserting The Battery; Battery Charge Indicator - Bosch GCM 18V-216 D Professional Originalbetriebsanleitung

Cordless sliding mitre saw
Recommended chargers
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Hole diameter
A) Measured at 20–25 °C with rechargeable battery ProCORE18V 8.0Ah.
B) Depends on battery in use
C) Limited performance at temperatures < 0 °C
Permitted workpiece dimensions (maximum/minimum): (see "Permissible workpiece dimensions", page 38)

Noise Information

Noise emission values determined according to
EN IEC 62841-3-9.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 93 dB(A); sound power level
107 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
poorly maintained, the noise emission value may differ. This
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
ficantly reduce noise emissions over the total working
period.

Rechargeable battery

Bosch sells some cordless power tools without a re-
chargeable battery. You can tell whether a rechargeable bat-
tery is included with the power tool by looking at the pack-
aging.
Charging the battery
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your power tool.
Note: Lithium-ion rechargeable batteries are supplied par-
tially charged according to international transport regula-
tions. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for
the first time.
Bosch Power Tools
GCM 18V-216 D
GAL 18...
GAX 18...
GAL 36...
mm 216
mm 1.2–1.8
mm 30

Inserting the Battery

Push the charged battery into the battery holder until it
clicks into place.
Removing the Battery
To remove the rechargeable battery, press the battery re-
lease button and pull the battery out. Do not use force to do
this.
The rechargeable battery has two locking levels to prevent
the battery from falling out if the battery release button is
pressed unintentionally. The rechargeable battery is held in
place by a spring when fitted in the power tool.

Battery charge indicator

The green LEDs on the battery charge indicator indicate the
state of charge of the battery. For safety reasons, it is only
possible to check the state of charge when the power tool is
not in operation.
Press the button for the battery charge indicator or
show the state of charge. This is also possible when the bat-
tery is removed.
If no LED lights up after pressing the button for the battery
charge indicator, then the battery is defective and must be
replaced.
Battery model GBA 18V...
LED
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Battery model ProCORE18V...
LED
5 × continuous green light
English | 33
GCM 18V-216 D
GAL 18...
GAX 18...
GAL 36...
216
1.2–1.8
25.4
to
Capacity
60–100 %
30–60 %
5–30 %
0–5 %
Capacity
80–100 %
1 609 92A 8HU | (20.12.2022)