Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11.
Transport and storage
When transporting the unit, protect it from shocks and tipping over, and do not place it "upside
down". Store the unit in a well-ventilated room where dry air is present and corrosive gases are not
present.
12.
Cleaning and maintenance
Pull the mains plug before each cleaning and when the unit is not in use and cool the unit
completely.
• Remove the spatter from the tip of the welding gun and check the condition of the parts. Damaged
parts must be replaced immediately.
Use only non-corrosive cleaning agents for cleaning the surfaces.
Do not spray the unit with a stream of water or immerse it in water.
Make sure that no water enters through the ventilation openings in the casing.
Clean the ventilation openings with a brush and compressed air.
After each cleaning, all the parts should be dried well before the unit is used again.
Store the unit in a dry and cool place protected from moisture and direct sunlight.
- Remove dust regularly with dry and clean compressed air.
13.
Regular inspection of the device
Check the unit regularly for damage. If this is the case, stop using the unit. Please contact your dealer
immediately for repair.
What should I do if a problem occurs?
Please contact your dealer and have the following information ready:
- Invoice number and serial number (the serial number is indicated on the rating plate).
• Potentially a photo of the defective part.
The service technician will be able to better determine what the problem is if you describe it as
precisely as possible. The more detailed you are, the faster they can help you!
NOTE: Never open the device without consulting customer service. This can lead to loss of warranty.
Werbung
Inhaltsverzeichnis
