Mma Welding - STAMOS S-MULTI 180H Bedienungsanleitung

MMA welding

1) Connect the welding gun cable to the connector marked with a "-" sign and twist the cable
plug to secure the connection.
2) Connect the ground cable to the connector marked with a "+" sign and twist the cable plug to
secure the connection.
Caution! Cable polarity may vary! All polarity information should be described on the
packaging provided by the electrode manufacturer!
3) Plug the power cord into an electrical outlet and start the machine. After connecting the
mass cable to the workpiece, work can begin.
8. Replacing the drive roller groove
CAUTION! All maintenance, replacement of parts, repairs or adjustments should be carried out with
the power supply disconnected from the device.
If you need to change the wire diameter, also replace the drive roller or adjust the position of the
drive roller.
1. Tilt the pressure adjustment lever to open the pressure roller.
2. Unscrew the drive roller mounting knob and make sure that the drive roller size is
appropriate for the wire being installed.
3. If necessary, pull the drive roller from the shaft and turn it to change the groove through
which the welding wire will move.
4. Reinstall the drive roller.
5. Tighten the drive roller mounting knob.
6. Close the pressure roller and set the pressure adjustment lever to the vertical position.
7. Adjust the pressure with the lever.