Coccolle Venti Bedienungsanleitung Seite 6

EN
Parts list:
1. Canopy
2. Backrest
3. Handlebar
4. Front basket
5. Front wheel
6. Footrest
7. Brake pedal
8. Back wheel
9. Back basket
10. Backrest adjustment switch
11. Push bar
12. Frame
Assembly steps:
1. Opening the rear part of the frame
Open: Open the rear wheel frame in the direction of the arrow as shown in the
Picture 1.
Fold: Press the button under the frame to fold the back wheel frame.
2. Rear wheels Installation
Insert the brakes into the relevant part of the rear wheel frame, and then insert
the rear wheel into the corresponding hole on the brake pedal to complete the
rear wheel installation.
(Pay attention to distinguish the left and right when you install the brake pedal)
3. Footrest Installation
Open: as shown in Picture 3, press the button to unfold the footrest, then open
left and right footrests' parts for use.
Close: Push the button to fold up the footrest, then fold the left and right
footrest's parts.
4. Back basket Installation
Put the back basket and its footrest on the frame along the dotted line as shown
in Picture 4, align the basket hole with the corresponding hole on the frame.
Please note that you must install back basket first.
5. Backrest Adjustment
As shown in Picture 5, press the buttons on both sides of the backrest to adjust
the angle of the backrest.
6. Front wheels/Front basket/Handlebar Installation
Insert the front wheel, front basket and handlebar according onto the relevant
part of the front frame, according Picture 6.
When inserting the front wheel, the arrow position on the fender should be
forward, and the handlebar button should be installed forward. Press the button
and insert it. After the installation,
please check that all the parts have been installed in the correct position,
otherwise they will be impossible to remove later. If it's necessary, press the
front button of the handlebar to remove the above three parts.
7. Bumper Bar
Press the button on the left and right to open the bumper bar, then place the
child into the tricycle's seat, fasten the seat belts and then close the bumper bar.
6