Detach Soft Goods; Care And Maintenance - Joie bold R Bedienungsanleitung

For installation with Isosafe system + 3-point-belt + top
tether
1. Make sure that both Isosafe connectors are securely
attached to their ISOFIX anchor points. The colors of the
indicators on both connectors should be completely green.
-1
38
2. The booster can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint
securely. -2& -3
38 38
3. Make sure that tether hook are securely attached to the
anchorage fitting. The colors of the indicators on tether
strap adjuster should be completely green.
4. Position shoulder belt through the shoulder belt guide
shown in -5
38
5. It is very important to ensure that any lap strap is worn low
down, so that the pelvis is firmly engaged. The booster is
shown as .
38
To ensure the correct head support height is obtained, the
bottom of the headrest MUST be even with the top of child's
shoulders as shown in
39
positioned in the red zone as shown in
15
-4
38
and the shoulder belt must be
.
40

Detach Soft Goods

see images -
41 45
!
Please refer - to remove shoulder strap cover, crotch
31 36
belt cover, buckle and harness straps, and keep them
properly.
!
To refit the seat pad simply reverse the steps above.

Care and Maintenance

!
Please wash the soft goods and inner padding with cold
water under 30°C.
!
Do not iron the soft goods.
!
Do not bleach or dry clean the soft goods.
!
Do not use undiluted neutral detergent gasoline or other
organic solvent to wash the booster. It may cause damage
to the booster.
!
Do not twist the soft goods and inner padding to dry with
great force. It may leave the soft goods and inner padding
with wrinkles.
!
Please hang dry the soft goods and inner padding in the
shade.
!
Please remove the booster from the vehicle seat if not in
use for a long period of time. Put the booster in a cool, dry
place and somewhere your child cannot access it.
16