Compliance With Standards - Honeywell Miller H700 Allgemeine Hinweise Zur Benutzung

Lateral attachment points: Resistance to a fall of 1m with a dummy
o
weighing 100 kg and 140 kg under the conditions stipulated by the
standard.
Ventral attachment point: Resistance to a fall of 1 m with a dummy
o
weighing 100 kg and 140 kg under the conditions stipulated by the
standard.
The shoulder attachment points is certified as compliant with the
requirement of standard EN1497:2007:
Static tests:
ü
Shoulder attachment points: Force of 15kN exerted between the
o
attachment element and the lower ring of the dummy for 3 min
Dynamic tests:
ü
Shoulder attachment points: Resistance to a fall of 1 m with a dummy
o
weighing 100 kg and 140 kg under the conditions stipulated by the
standard.

1-8 COMPLIANCE WITH STANDARDS

This equipment has undergone a standard inspection according to
standards EN361, EN358 and EN1497 with a
issued an EU certificate confirming that all equipment produced and the
corresponding instructions comply with REGULATION (EU) 2016/425.
This equipment has undergone a standard inspection according to
standards EN361, EN358 and EN1497 with an approved body, (cf. P198),
which issued an UK certificate confirming that all equipment produced and
the corresponding instructions comply with Protective Equipment
(Enforcement) Regulations 2018 (SI 2018 No. 390) -PPE Regulation
(EU)2016/425.
1-9 LIMITATIONS AND CAPABILITIES
If there is a risk of falling, only a fall arrest harness that complies with
standard EN361 is authorized for use as a body prehension device in a fall
arrest system. It is imperative that this harness be complemented by a
collective or individual protection device against falls from height (fall arrest
system complying with standard EN363).
The fall arrest harness may be connected to a fall arrest system only at its
dorsal point or chest point. The lateral points or vertical point of the
positioning belt shall in no case be used for attaching a fall arrest system.
These points only allow a work positioning system to be connected. Shoulder
points must not be used for fall arrest purposes also.Never use this harness
for load carrying.
If the harness has suffered a fall, it must be withdrawn from the field.
1-10 TRAINING
notified body, (cf. P196), which
17