While In Use - Honeywell Miller H700 Allgemeine Hinweise Zur Benutzung

No deformation of the D-links,
ü
Correct operation of the buckle systems,
ü
Integrity of the seams,
ü
Good condition of the metal components.
ü
2-4
PUTTING AND ADJUSTMENT ON THE FALL ARREST HARNESS
Please proceed as follows in order to put your harness on without difficulty
(cf. Fig.V ):
Take the harness by the Back 'D' ring, (cf. A)
ü
Put on the shoulder straps one after the other, (cf. B-C)
ü
Pass the male buckle through the chest V-ring, and close the chest strap
ü
(cf. D-E)
Fasten the belt around the waist (cf. F)
ü
Pass the thigh straps between your legs, in order to lock them into the
ü
buckles on either side of your hips. (cf. G-H)Be careful not to cross the
thigh straps
Adjust the thigh straps by pulling or releasing the strap end (cf. I)
ü
Adjust the belt's adjustment buckle by pulling or releasing the end of the
ü
strap (cf. J)
Adjust the front adjustment buckles one after the other by pulling on or
ü
releasing the end of the strap. (cf. K-L)
For a fall arrest harness to be totally efficient, it must be properly adjusted
(not too tight or too loose,and thigh straps must be in a horizontal position
on the legs). Please note: harnesses made of elasticised webbing require a
tighter fit.
Once your harness is adjusted, check that no webbing is twisted or crossed
over, that all the buckles are correctly attached and that the back 'D' is
situated at the level of the shoulder blades.
For optimum safety, do not hesitate to seek help.

WHILE IN USE

Protect your PPE against all risks associated with the work environment:
thermal, electrical, or mechanical shocks, acid splashes, sharp edges, etc.
While in use, regularly inspect the adjustment and/or attachment elements.
If your harness has been subjected to a fall, your PPE must be withdrawn
from service and returned to the manufacturer or a qualified repair center for
inspection or disposal.
2-5
HOW TO TAKE OFF THE HARNESS
After work, once there is no risk of fall from height anymore, unlock the
different buckles to take off the harness.
3 - USE
4 - 1 USE INFORMATION PRIOR TO USE
USAGE WITH A FALL ARREST SYSTEM
To properly attach the fall arrest harness to an anchorage point (compliant
19