Wiegand Interface; Start-Up; Operation With Transponders; Allocate Addresses (Rs-485) - Honeywell Accentic Montage- Und Bedienungsanleitung

Mounting and Operating
5.3

Wiegand interface

026420.20
6.

Start-up

6.1

Operation with transponders

The transponder should be held approximately in the middle of this field
In order to achieve a greater transmission range when using the transponder, a
relatively high current is required during transmission (<50 mA).
Without transponder transmission (5 sec. after the last transmission), the
X
automatically switches from active mode to low current mode and thus reduces
the current consumption on average to <11 mA.
6.2 Allocate addresses
6.2.1

Introduction

Every reader operated at an AC module bus must have its
the AC system prevents addresses from being allocated several times.
Possible
address range:
The following information is intended to assist you in choosing the best methods for your special
requirement. A detailed description on the individual methods can be found in the following
chapters.
1.) Manually via the central control unit
Enter the unique number (serial number) of the reader plus the desired address via the
programming of the central control unit. The address is then stored in the reader.
Recommended standard methods.
2.) Automatically with transponder
Start the process with a transponder in the reading area of the reader. The address is
allocated automatically and then stored in the reader. As long as the address allocation
mode is active, several readers can be automatically allocated addresses in succession.
Recommendation:
Suitable for shorter distances between the AC central control unit and the individual
readers. (Manual input of the unique numbers of the readers is not required).
Instructions - proX2-reader "Accentic" without keypad
If the transponder is used in conjunction with a reader in low current
mode, it may take up to 1.2 sec. until it starts operating. Evaluation
takes place within 0.9 sec. when the read mode is activated.
1 to 32 (address 0 not applicable)
(see 6.2.4)
(see 6.2.5)
red
blue
grey
red/blue
green
Shield
address. A
own
+U_b 12 V DC
0 V
D1
D0
LED green
plausibility check
21
reader
in