Aligning The Appliance - Haier HSW59F18EIMM Bedienungsanleitung

WARNING!
Ensure that the connections are always firm, dry and leak free.
>Make sure the hose is never crushed, kinked, or twisted.
10.6

Aligning the appliance

The appliance should be placed on a flat and
solid surface.
1. Tit the appliance slightly backwards (Fig.
10.6).
2. Set the feet to the desired level. Make sure
the distance to the wall on the hinge sides is
at le ast 10 cm.
3. The stability can be checked by alternately
bumping on the diagonals. The slightly
swaying should be the same in both
directions. Otherwise the frame can warp
possible leaking door seals are the result.
A low tendency to the rear facilitates the
closing of the doors.
10.7 Fine tuning of the doors
If the doors are still not in one level after
levelling the doors by the feet, this mismatch
can be remedied by turning the hinge lifting
shaft at the right bottom corner of
refrigerating door with a spanner(Fig.10.7)
Clockwise turn lifting shaft with spanner to
lower door height (Fig.10.7-1).
Antic lock wise turn lifting shaft with spanner
to llft door height (Fig.10.7-2).
Equipment
max 45°
EN
25