Operation Via Artnet - EuroLite LED IP Atmo Blinder 9 Bedienungsanleitung

Operation via ArtNet

To be able to operate the device in ArtNet mode, it must first be set to ArtNet under the Control Mode menu
item (see Menu structure).
For use via appropriate lighting control software supporting ArtNet. The device can be configured via the
LCD and operating buttons.
Data Connection
The device uses a RJ45 data connection for connection to a computer or a previous or subsequent device.
To link all data ports the wiring can be carried out according to the following two installation methods.
Please refer to the instructions under Menu structure.
Only use UTP cable type CAT-5e or higher.
28/40
Interconnect the devices with
network cables. The Ethernet
ports can be used as inputs and
outputs as desired.
Connect the first device in the
chain to the computer's network
card (optionally through a
network switch) with a network
cable.
If needed, cables up to 100
meters long may be used (point-
to-point connection provided).
Different lengths are available as
accessories.
00146662, Version 1.0