Herunterladen Inhalt Inhalt Diese Seite drucken

Power Supply; Operation; Stand-Alone Mode - EuroLite LED IP Atmo Blinder 9 Bedienungsanleitung

Wetterfester blinder mit pixelansteuerung und atmo-cluster
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

POWER SUPPLY

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts. The
power connectors are designed according to protection class IP65. Matching connection cables with special
plugs are optionally available. When not in use, make absolutely sure to close the connections with the
rubber sealing caps to prevent moisture and dirt from penetrating.
1
Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2
To switch off the unit, disconnect the power plug.
3
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
4
The jack POWER OUT allows for power supply of further devices. To interconnect several devices,
connect the jack POWER OUT to the input POWER IN of the next unit until all units are connected. In
this manner, up to 4 devices can be linked at 230/240 input voltage and up to 2 devices at 110/115 input
voltage.

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.

Stand-alone mode

In stand-alone mode, the device can be used without controller. Disconnect the device from the controller
and call up the menu you want to use. Please refer to the instructions under Menu structure.
The main menu is accessed by pressing ENTER. Browse through the menu by pressing UP or DOWN.
Press ENTER in order to select the desired menu. You can change the selection by pressing UP or DOWN.
Press ENTER in order to confirm. You can leave every mode by pressing MENU. The functions provided are
described in the following sections.
29/40
00146662, Version 1.0

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

41606430

Inhaltsverzeichnis