Cleaning The Interior; Textile Parts - Shark SPARTAN GT PRO Benutzerhandbuch

CLEANING THE INTERIOR

All interior fabric materials are
washable; to avoid their deterio-
ration, it is necessary to strictly
adhere to the following guidelines:
The cheek pads and peak must
be hand-washed in warm soapy
water (at approx. 30°C). Avoid
using harsh detergents, but rather
a small dose of detergent specifi-
cally designated for delicate fabrics
or else a very mild soap.
Prior to helmet use, it is essential
to ensure that the fabrics and
foams have completely dried. This
drying step must be carried out at
room temperature. Never iron any
of the fabric materials. For parts
with a leather finish or fabrics
bonded to safety components, use
a sponge or slightly dampened
cloth with just a bit of mild soap
and then rinse in clean water.
Avoid using too much water on
components made of polystyrene.
You must fully ensure that all inte-
rior parts are perfectly dry before
using the helmet.
WARNING! Damaging the
internal foam will alter your
actual helmet size. If no lon-
ger adjusted to fit your head,
the helmet may come off, thus
leaving your head exposed wit-
hout protection and potentially
causing serious, or even fatal,
injuries.
THE TEXTILE PARTS
The Spartan GT Pro Carbon -
Spartan GT Pro comfort fabrics and
foams will help you better appre-
ciate your helmet's performance.
The parts in contact with your skin
are made with a fabric guaranteed
to be pleasant to the touch, in
addition to offering a high level of
perspiration absorption and good
resistance to ageing. By relying on
our surface treatment, we have
successfully limited the risks of
mould and bacteria build-up.
WARNING! Despite being
rigorously selected for their
strength and durability over time,
all parts of the interior lining are
subjected to normal wear, depen-
ding on: the level of care and main-
tenance, the time in use, and the
acidity properties of your perspira-
tion. Should you observe wear-in-
duced ageing, we advise replacing
the interior fabric and foam in order
to extend the lifetime of a perfectly
clean helmet capable of providing
the requisite level of comfort. Your
retailer may be able to propose
replacements and, as an option,
cheek pads of different thicknesses
and densities should the standard
choices not match the morphology
of your face.
WARNING! Each time you
put on your helmet, check
the fit as discussed in "Choose your
size".
9