Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Important Notes on Test Execution and Self-assess-
ment
After the last sip of alcohol, you should wait at least
15 minutes, as there may still be residual alcohol in the
oral cavity, which influences the measurement result.
Also smoking should be avoided before a test, as ciga-
rette smoke harms the sensor.
For each test you should use a new mouthpiece – not
only for hygienic reasons, but also because an already
used mouthpiece can influence the next measurement
result. The mouthpiece could contain residual alcohol,
which would affect the new test result when the same
mouthpiece is used again (this for example could show
an alcoholization of a person who hasn`t drunken any
alcohol).
If „FLOW" or „FLo" appears on the display, the given bre-
ath sample was insufficient or ended too soon. Blow into
the mouthpiece for about 4 seconds constantly (without
a break) – preferably as if you were whistling without
a sound.
If the same person performs 2 tests consecutively, then
wait at least 3 minutes between the two tests, as a too
short waiting time may cause different measurement re-
sults. The air exhaled from the lungs is, after a test, no
longer enriched with the same alcohol content as in the
previous test. Therefore, an immediate second test will
indicate a lower test result.
All measured values determined with this breathalyzer
are always indicative and not legally binding.
8
ACE_A_BA_20190221.indd 8
27.02.2019 11:35:03
Werbung
