Ace instruments ACE A Bedienungsanleitung Seite 29

4. As soon as the beeping stops you hear a "clack" tone and
a double beep tone (the test is finished). If the breath sample
was not sufficient you will see „Flo" on the display. Push the start
button and start a new test.
5. After a successful test the device is analyzing the breath
sample, you see several lines moving in clockwise circles
around the display. After a few seconds the test result is dis-
played for 5 seconds (with 3 digits and 2 decimals) in ‰, then
for 2.5 seconds in mg/L (= UK setting) and then for 2.5 seconds
in % BAC (with 4 digits and 3 decimals). If the test result is higher
than 0.50‰ or 0.25mg/L or 0.05% BAC, then you can hear a warn
signal (beep sound) for about 10 seconds.
Note: The device will turn off automatically if it is not in use for
about 3 minutes, additionally you hear a beep tone and on the
display you see „Out" and afterwards „OFF". If you want to con-
duct a new test, please press the power button. You can turn
off the device manually if you constantly press the power button
for about 5 seconds, you shortly see „OFF" on the display and
the device turns off.
ACE Instruments recommends
Š
Š
Š
ACE_A_BA_20190221.indd 20
Always use a new mouthpiece for each person and test
that is conducted. ACE Instruments assumes no liability
for any damages that may arise when several people use
the same mouthpiece for multiple tests.
Only use the provided individually packaged and hy-
gienic mouthpieces. During each test the breathalyzer's
internal and external parts come into contact with human
secretion (saliva, blood, sweat, etc.)!
Use safety gloves when pulling out a mouthpiece used
by another person! You can buy appropriate gloves at
ACE Technik (www.ace-technik.de).
20
27.02.2019 11:35:05