Mounting / Dismounting The Hot Shoe Holder; Mounting / Dismounting The Tablet / Smartphone Holder On The Hot Shoe Mount; Clamping The Tablet In The Holder Or Removing It From The Holder; Clamping The Smartphone In The Holder Or Removing It From The Holder - Instarter Spectar Bi-Color LED Ring 3.5 Kit Gebrauchsanleitung
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.4 Mounting / dismounting the hot shoe holder
1.
Slide the hot shoe bracket (14) into one of the hot shoe connections (16)
on the back for mounting from the front.
2.
Pull the hot shoe bracket (14) backwards out of the hot shoe
connection (16) for disassembly.
7.5 Mounting / dismounting the tablet / smartphone holder on the
hot shoe mount.
NOTE - The tablet holder has
mounting.
1.
Screw the ¼ inch thread of the bracket (8/15) onto the ¼ inch screw of
the hot shoe bracket (14) until they are firmly connected and nothing
wobbles.
2.
Unscrew the ¼ inch thread of the bracket (8/15) from the ¼ inch screw of
the hot shoe bracket (14) and remove the bracket (8/15).
7.6 Clamping the tablet in the holder or removing it from the holder
The tablet holder is suitable for all common tablets from 11-19 cm wide.
It can be used horizontally or vertically because of the two clamping
brackets.
1.
Pull the flexible clamp (8a) of the holder (8) upwards.
2.
Position the tablet between the two brackets and carefully move the
clamping bracket (8a) down again until the holder has gripped and the
tablet is held securely.
3.
To remove the tablet, hold it with one hand and pull up the clamp (8a)
with the other hand.
7.7 Clamping the smartphone in the holder or removing it from
the holder
The holder is suitable for all common smartphones 5.5-9.5 cm wide.
1.
Slightly open the clamp (15a) of the holder (15).
2.
Turn the bracket (15b) to the appropriate position and tighten the
bracket lock (15a) again.
3.
If necessary, loosen the holder fixing screw (15c), clamp the
smartphone and tighten the screw until the smartphone is held.
Do not tighten the screw too much, so that the smartphone is not
damaged!
38
2×
¼ inch threads for horizontal and vertical
Werbung
Inhaltsverzeichnis
