Rotate Luminaire; Pivot Luminaire - Instarter Spectar Bi-Color LED Ring 3.5 Kit Gebrauchsanleitung

WARNING
Danger from heat, electricity or fire
The lamps and the housing become very hot during operation.
The luminaire can overheat (icon
the ventilation slots covered. In case of overheating or short-circuit,
the luminaire itself and flammable materials near the luminaire may
start to burn.
■ Do not cover the ventilation slots (11) during operation or when
cooling down.
■ Remove flammable materials from the immediate vicinity of the
luminaire.
■ Do not touch warm or hot parts of the luminaire during operation or
cooling down.
■ Allow the luminaire to cool down completely and disconnect it from
the power supply before mounting, disassembling or cleaning.
You can operate the luminaire either manually via the 2 rotary knobs (5+7)
and the display (6) on the front or via your smartphone using the Instarter
Spectar LED App (iOS or Android) and Bluetooth.
The lamp must be mounted on the enclosed or a commercially available
lamp stand with 5/8 inch spigot for operation.
Power is supplied either by two NP-F rechargeable batteries (not included)
or by the included mains adapter.

7.2 Rotate luminaire

1. Loosen the fixing screw of the tripod holder(10) slightly.
Hold the luminaire while doing this.
2. Turn the luminaire to the desired position.
3. Tighten the tripod holder of the bracket (10) again.

7.3 Pivot luminaire

1. Slightly loosen the fixing screw of the svivel joint (11) gently.
Hold the luminaire while doing this.
2. Swivel the luminaire to the desired position.
3. Tighten the swivel joint of the bracket (11) again.
in display) if you operate it with
EN
37