Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.
Commissioning
WARNING
Danger, due to incorrect use or handling.
■ Observe the safety instructions in the respective sections for all
activities.
6.1 Setting up the tripod
1.
Loosen the screw of the stand foot and fold the stand foot down.
2.
Tighten the screw of the stand foot.
3.
Set up the tripod (4) securely and level.
4.
Loosen the two screws of the tripod extensions and pull out the
tripod rods.
5.
Tighten the two screws of the tripod extensions.
6.2 Mounting the luminaire on the tripod
Always use the luminaire on a standard lamp tripod with a 5/8" spigot.
1.
Set up the tripod according to chapter 6.1.
2.
Loosen the fixing screw of the tripod holder (10) on the lamp and
place the holder on the spigot (3) of the tripod (4).
3.
Tighten the fixing screw of the bracket firmly again (10) and make
sure that it grips the spigot at the narrowest point to prevent it from
slipping off.
4.
Check that the luminaire is held on the stand and that the stand is secure.
6.3 Power supply via mains adapter
1.
Switch off the luminaire so that you are not dazzled when you switch it
on. To do this, move the on/off switch (20) to the position [0].
2.
Insert the plug of the power supply unit supplied (12) into the
socket (18) on the back of the luminaire.
3.
Connect the appliance plug of the mains cable (9) to the corresponding
socket of the power supply unit (12).
4.
Connect the mains plug of the mains cable (9) to a protective
earthed socket of the local mains supply (AC 100-240 V, 50/60 Hz,
see technical data).
34
Werbung
Inhaltsverzeichnis
