Starting The Tool; Blade Replacement - Cross Tools CSC 230-1200 PRO Original-Gebrauchsanweisung

Translation of original operating instructions
Do not use the tool if the functional test described above failed.
5.6. Before Start-up
Check the following points:
1. Keep the mains lead away from moving parts.
2. Make sure that the voltage of the motor corresponds to the mains voltage (230V,
50Hz).
3. Make sure to use a grounded mains connection (wall socket).
4. Make sure that the mains lead and plug are in a good condition without loose ends or
damage.
5. Place the cutting machine on a flat surface to prevent instability.
5.7.

Starting the tool

Do not apply side-pressure to the diamond blade.
This can lead to damage on the blade and the risk of
personal injuries.
1. Insert the mains plug into a socket with safety contact. The safety contact must be protected with a fuse e.g. in the
terminal box. If an extension cable is required, please note that with an extension length of up to 20m, a cable with
a cross section of 1.5mm² must be used.
2. Always check the functionality of the PRCD safety switch as described in chapter 5.5 before switching on the tool.
For starting the tool, press the green button marked "I".
3.
For stopping the tool, press the red button marked "O" (see Fig 15).
4.
16-1
5. Making a straight cut. Loosen the locating screw (17). Adjust the angular guide in straight accordance with the
gauge (18). Set the necessary width by adjusting the inner fence. Position the tile against the fence and the angular
guide (6) and move the blade with a soft movement. Do not put too much pressure on the tile to prevent the motor
from overloading.
6. Making a diagonal cut. Follow the same procedure as for straight cuts, but use the angular guide in conjunction
with the fence. Ensure that the tile is held firmly in the angular guide before making the cut. For 45° miter cuts, a
45° cutting assistant is available.
7. Cutting with the table at an angle. Loosen the two buttons on the two rail stands. Tilt the rail with the diamond
blade to the desired angle. Tighten the two buttons and make the cut.

6. Blade replacement

WARNING! Disconnect the power supply and turn the switch on OFF before adjusting or maintaining
the tool! Never use toothed blades for this tool.
Choice of blade:
Only use diamond blades with continuous rim and recommended by the manufacturer. For the type CSC
230/1200 PRO the diameter of the blade needs to be 230 mm, the bore of the blade must be 25,4 mm.
16-2
8
15
19