Setup - Cross Tools CSC 230-1200 PRO Original-Gebrauchsanweisung

Translation of original operating instructions
Caution! Switch off cutter immediately and pull out mains plug if
- power cord, plug, socket or switch are damaged
- motor is overheating
- smoke is emitted or there is a smell of charred insulating material.
28. Use only diamond blades for which the maximum possible speed is higher than the maximum spindle speed of the
cutter and the material to be cut.
29. When transporting the tool, always use transportation devices. Never grab protection devices for handling or
transportation.
30. Fill the cooling tank 5/6 full of water. It is quite normal for the tool to cause splashes during use.
31. Only use undamaged diamond blades. Immediately replace any cracked blades.
4.9. Transportation
Before any transportation, the cutting unit must be secured to the bar guide with the locating screw (13).
Fold the machine for long-distance transports. Two persons are required to move the cutter. One person grabs the
handle on one side; the second person grabs the handle on the other side. Lift the tool off the ground for moving.
For short-distance transports, mount the provided wheels to the bottom of the supporting legs. See chapter on wheel
mounting.
4.10. Designated use of the stone cutter
The electrical stone cutters CSC 230-1200 PRO were developed for the cutting of ceramic, marble and granite tiles. The
blade of this cutter can be tilted up to 45°. A water pump cools the diamond blade.
Warning: Never attempt to cut wood, metal and other similar material with this machine.
Never use this machine in potential explosive environment or underground environment.

5. Setup

5.1. Assembly
Read the manual carefully before assembly. Clean the work
area.
Take the supporting legs out of the box.
Take the tool out of the box. The tool is already assembled.
Take the accessories out of the water tank.
Mount the 4-edge cover caps in the bottom of the feet
Lay the tool on the ground on its side and insert the feet into the
machine (Fig. 4)
Screw all 4 legs tightly in place with a knurled screw. (Fig. 5)
Fasten the handle on the cutting unit with the two provided screws (Fig. 6).
During
6
transportation,
the cutting unit
is secured.
Please loosen
the locating
screw (13)
before setup
(Fig. 7).
Warning: Before any maintenance work, make sure to re-secure the cutting unit to the bar
guide with the positioning screw and the fixation nut (Fig 7 and 8, part 13).
4
7
6
5
8
17