Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation of water pump: The water pump is
installed lying (Fig. 9).
Fill the tank (9) with water. Do not add chemicals
or detergents to the water. If the stopper on the
bottom of the water tank is taken out, the water
will drain.
For the cutting of large tiles, extension table
(Fig.2, 8) can be used. Push the extension into the
frame from above (Fig. 10). For horizontal
adjustment please use the setting screws (Fig. 10
No. 19).
5.2.
Disassembly
Please follow the steps in reverse order.
5.3.
Mounting of the transport handles
Mount the two transport handles with the beveled sides facing
downwards on the front side of the tile cutting machine according to
Fig. 11.
5.4.
Wheel Assembly
First, screw the lugs for attaching the wheels to the two support legs on
the side opposite the transport handles. (Fig. 12-1) Tighten the screws well.
Mount the wheels by inserting the spacer sleeve into the caster (Fig. 12-2) and then mounting them into
the lugs with the supplied screws (Fig. 12-3 to 12-5).
For transport, use the transport handles to lift the machine so that the unit is standing on the wheels,
now you can easily move the machine on a flat surface (Fig. 13).
12-1
12-4
5.5.
PRCD safety switch (see Fig 14)
1.
Insert the mains plug into a stationary socket.
Push the RESET button („0"): The status indicator light (Fig. 14, No. 2) should be lit.
2.
Push the button marked „T": Now, the status indicator light should go out.
3.
Push the RESET button („0") to start using the tool.
4.
18
9
12-2
12-5
7
Translation of original operating instructions
10
11
12-3
13
3
14
Werbung
Inhaltsverzeichnis
Fehlerbehebung
